This Shotgun Barrel Clamp With Light Rail & QD Point is:

• CNC Machined From 6061 T6 Aluminium
• MIL-SPEC Type 3 Hard Anodized.
• M1913 light rail.
• QD cut sling attachment

Each clamp kit comes with the following:

• Two clamp halves
• One M1913 light rail
• One QD cut sling attachment
• Two rubber gaskets
• Two short screws
• Two long screws
• Instructions

Confirmed fitment on:

• Browning BPS police
• Rem 870,1100,1187
• Benelli M3 And Clones
• Benelli M4 and Clones
• Mossberg 500 7 shot
• Mossberg 930
• Win 1200,1300 7 shot
• Norinco/Hawn HP9 Pardner 18inch
• Blue Line 870 Clones
• Beretta 1301T/A300 Patrol

Many, Many Others

MADE IN CANADA

** does not fit Benelli M2, Benelli Nova

Installation: Parts are partially assembled for demonstrative purposes.

To install, you must first detach the light rail and QD from the clamp sides. Use the two longer screws in the outer holes to carefully affix the clamp sides to your barrel and magazine tube, with the rubber gaskets on the inside, to protect your gun and prevent slippage. Then use the smaller two screws, in the center holes to re-attach the rail and QD to the clamp.

Please note; If you are trying to put a screw through the QD hole and find that the holes are misaligned, it is because you are installing it incorrectly. No screws are meant to go through the QD hole. You must first remove the QD rail and M1913 rail, install the clamp on the firearm, then install the accessory rails to the clamp.

SKU: CRAIL-QD